RIGOL Technologies

Welcome, Guest Login

Support Center

Counter and Totalizer Setup

Last Updated: Aug 30, 2019 04:30PM PDT
The MSO5000 and the DS7000 series come with a built in frequency counter and totalizer which can be used at any time.  The frequency counter and the totalizer are meant to be used only on the analog channels of the instrument.

With the instrument already triggering properly on the signal press “Measure” and then press “Counter” on the right hand side of the display.  This will bring you to the frequency counter and totalizer menu and will allow you to change the channel that the tool is monitoring and the measurement that you wish to use at that time.

In the image below, I set the digital voltmeter to monitor channel 1 of my square wave.
 


Additionally, with the instrument already triggering properly on the signal press “Measure” and then press “Totalizer” on the right hand side of the display.  This will bring you to the totalizer menu and will allow you to change the channel that the tool is monitoring and the measurement that you wish to use at that time.

In the image below, I set the totalizer to monitor channel 1 of my square wave. 




 
Login above for personalized content

RIGOL USA Web Site

f14c465fd642ac49fa5a4bd437615e15@rigol.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete